Discussion in 'Off-Topic' started by Hooligan, Feb 3, 2011.
$300 shipped for that big of a bar... Must be a pretty ****ty bar.
Join RnagerForum.com Today!
new block is already built up. 306 with all forged internals. Ported heads and port matched intake. Aught to run alright. May tune it for 24lb injectors just to see. Also slapped some 1.7 rocker arms on it
OK nice one.
Watch the injector size and it should be dependent on your Throttle Body size.
What cam did you put in, hopefully not the 303 Stang cam, there are so many so much better.
Make sure to get an EFI Cam, lobe separation is different on the EFI versus a carb’d cam.
I never liked the 1.7 Rocker Arms, if/when you buy a cam you can get all of the lift you need designed in the cam lobes.
My cam is a short duration around 268, I think , will have to look that up, and the lift is 510 and 512 @ .050 lift.
Hopefully this will let the engine breath better and produce not only more low end torque but more higher end HP.
I know almost the same thing as adding the higher ratio rockers but when you buy the cam kit and all of the parts as a kit you get everything machined to work together.
Just me, good luck on the new engine.
Is there a build thread on this ?
holy ****!!! nobody wanna chat anymore!!???
I'll chat whats up?
hey wat's going on????? why is it soo quite here??
Cause you buggers only come here once in a while!
lol! that's true!
how u been????
Look whos alive!!
I been good man haha
The Steppie Rear Bumper Prototype Project is almost completed.
Thinking on the painting process… what to do.
I wanted Line-X but not too sure, painting is easier and can be repaired easier.
Maybe paint it first then Line-X later on.
How’s everyone doing on the site.
Everyone working ?
lol!! yep!! so wat's new????
bought another old homelite for the collection at a swapmeet today, it's MINT also got a CB for the truck for $5, came with a noise canceler thingy and an aux speaker, the guy also threw in a bearcat 210 police scanner for free plus sold a ton of junk, and a vespa!
got my u joint done today. holy FAWK was it bad. I'll post pics in my ujoint thread later and link it
got my new CB installed, sounds pretty good
Alway good to have some communications in the vehicle.
Make make of radio ?
Put on a new pair for silicon wipers by Rainex (sp).
Last set lasted about five years and hope the new ones will get me close to that.
What a difference, smooth, quite wipes.
well, my buggman red LED tail lights **** the bed recently. My dad noticed I had no brakes. So i checked em, one had compeltely burnt and fallen off. the other was just a tad burnt.
the reverse lights are fine though.
dropped the stockers back in.
^^send him a PM and let him know
might have to get myself some of those wiper blades.....
make of the radio is a Realistic (older model), which i got at the swapmeet for $5. came with an external speaker and an in-line noise filter, along with controls for RF gain and Tone, which my little cobra 19 lacked. i still need to tune my antenna but the new radio made a helluva differance.
Separate names with a comma.