Urgent Help Needed!!

Yup look for the big rubber circle behind the brake pedal. Poke a hole in the rubber and you're set
 
If you wanted you could run the wires out under the driver's seat.
There is a plug where wires go out.
It will take a little more wire and you will nave to dress it up some but there is more than one way to get the wire out.
 
Looks good.

There are plenty of How-To’s but I was wondering, did you follow a How-To and did everything come apart easily ?
Did you run into any problems ?

Thanks, I have to do this !
 
Scrambler82 said:
Looks good.

There are plenty of How-To’s but I was wondering, did you follow a How-To and did everything come apart easily ?
Did you run into any problems ?

Thanks, I have to do this !
Click to expand...

The worst and hardest part is getting the new Thunderbolt mirror out of the factory frame and then getting the new mirror in the stock frame after cutting the hole out for the LED's....Handling the new mirror makes your butt pucker because it takes a bit of force to get it out first off then getting it in...When putting the new mirror in the old frame a heat gun is a must, the edge must be soft and flexible to get the TB mirror in...We ended up tapping the turn signal wires by the parking brake...Be very carefull cutting the glue on the new mirrors because you can easily cut the led connection wire if not careful...We used a Dremel tool fine die grinder to cut the holes for the led cluster to fit in to the old frame..It took 2 of us about 6 hours to complete the job...Feel free to pm me if you need advice...Set your mind and hands to go very slow and careful and have lots of sharp blades on hand and don't cut yourself...Worst case scenario is having to buy another set of mirrors...Best of luck Bob C.
 
Last edited:
When I installed mine the Thunderbolts came with an instruction sheet even.
, take your time like Bob said it should be no problem
 
You must log in or register to reply here.
Back
Top