mr1996ranger
New Member
i did just that today and took all of 20 minutes. runs like new but guna drive it for a week or so just to make sure.
Idling issue
- Thread starter mr1996ranger
- Start date
mr1996ranger
New Member
hey guys im back for the same issue.... its been about 3 months and my 1996 ranger recently started its idling fits again... wen it comes down from the rpm's the motor wats to almost die and has a couple times and wen im driving it gets stuck in high rpm's.. heres the stuff i have already done: new spark plugs and wires (correct gap) new idle control valve, replace all dry vacuum lines and new egr valve.. i even tryed messing with the idle to see if that did anything and im still getting no where and tired of spending money... any help?
mr1996ranger
New Member
yes a number of times
mr1996ranger
New Member
yep hasnt thrown any codes for those
mr1996ranger
New Member
i really dont know wat else to try
mr1996ranger
New Member
that makes sense but idk why the problem went away for a couple months and then started again
Redneck_ranger
Banned
Check the O2 sensor too... Sometimes they go bad and make it run rough. Not sure if they always throw a code on it
mr1996ranger
New Member
wat engine is yours? cuz i have the I4 and i have two coil packs and eight plugs and wires
Redneck_ranger
Banned
We both have the 4.0 SOHC
mr1996ranger
New Member
ill do a little more research but if its comes down to it ill have the both coil packs checked and hopefully fix it.. thanks guys!
Redneck_ranger
Banned
Good luck man, if we find anything we'll let you know.
Hooligan
Rangerholic!!
I had the same engine in my 93, 2 packs one was bad. Also if it were an O2 sensor, it WILL throw a code
Redneck_ranger
Banned
Not on my buddy's truck...lol It was weird.
Hooligan
Rangerholic!!
I'm sure any of your "buddies" have the weird happen alot lol. On REGULAR rangers and pretty much any vehicle..an )2 sensor WILL throw a code
mr1996ranger
New Member
i actually just came from outside and i did a little test.. the motor is capable of running off of only one coil pack so i unplugged each one to see if i hear i difference... i unplugged the back one and the truck ran smooth.. i unplugged the front one and the truck just about died leading me to believe that the back one is bad... wat do you guys think?