I rescently bought an Endo cam for 20 buks off amazon it has a great picture and a handy bag of tools that attach to it. It’s real flexible and plugs right into your smartphone the light on it along with the magnet or retrieving spring should do the job
Thanks Tom#3 was maybe 30-35lbs lower than the rest of cylinders and is firing. Coolant system has no leaks but will go thru a gallon or more in a week. Considerable and constant water coming out the exhaust from start up to shut down. I don’t drive it off the property often so it haven’t...
I have 98 xlt 3.0 and have noticed a rough idle last couple weeks. Yesterday I noticed water spitting out exhaust. Oil don’t show milk or oil cap. I ran compression and # 3 is low. Am I looking at gasket PLUS A BAD HEAD? Any way to run test to determine if it’s valve or cracked head?
Well I went and exchanged my new pump for another new pump, new high pressure and return hoses and followed the instructions to it all. It all seemed very promising even to the point I thought I got a bum pump, until I started the motor!
Thanks a bunch!! Imma go get a new return hose or new nylon seals for that threaded end. I no it’s sposed to have some play but it’s got a lot more than the pressure hose has but has anyone ever experienced this crazy spinning of the steering wheel? Soon as motor starts you best be holding that...
I been getting gurgles of air from it with motor off and on by turning steer wheel but damn how much air can it hold? And it don’t show any improvement am actually wore out from turning it
Since my last post I have put new pump on with same issues happeningmotor off, wheels off ground, steering wheel turns in both directions, start motor and steering wheel takes off on its own unable to physically turn it’s down pump hums real loud like it’s empty. Turn motor back off and...
Well the thing is that my steering was functional b4 but now it’s not I figured that was due to having lines disconected/drained I’ve never experienced a lol up like this and then there is the sudden arm breaking steering wheel spin when I start the engine?
I recently pulled my power steering because it was humming and wasn’t turning very well. Long story short I wound up having to put old one back in while a waited for new one to arise. When I start truck up, wheels off ground, the steering wheel jerks crazy to one or other direction when I try to...
I got it off it looked like it had a hex bolt but it was part of the shaft. Now I can’t get system working I had allot of air bubbles come out but now I start engine and steering wheel takes off and then locks up humming the fluid level raises up some as I turn wheel with engine off and wheels...