currently working on a new mod....

Discussion in '1998 - 2011 Ford Ranger' started by klinger86, Jan 19, 2012.

  1. OP
    klinger86

    klinger86 Moderator

    Well guys version 1 failed miserably. Back to the drawing board and to start work on version 1.1.
     
  2. Ranger Forum Sign Up!

    Join RangerForum.com Today - It's Totally Free!

    Are you a Ford Ranger fan? If so we invite you to join our community and see what it has to offer. Our site is specifically designed for you and it's a great place for Ford Ranger Fans to meet online.
    Once you join you'll be able to post messages, upload pictures of your Ford, and have a great time with other Ranger fans. Whether your an old timer or just bought your Ford you'll find that Ranger Forum is a great community to join. Best of all it's totally free!

    Join RnagerForum.com Today! JOIN FOR FREE

  3. 00redranger

    00redranger New Member

    How'd it fail?
     
  4. OP
    klinger86

    klinger86 Moderator

    with the parking lights on the turns on the front wouldnt work.... so i have to figure out how to isolate the two wires so it can come on with the parking lights and still flash with the turn signals....
     
  5. OP
    klinger86

    klinger86 Moderator

    dont know if a relay would work with this.... hmmmmm now that you mention it it may work.... but have to find a relay schematic and figure out how to wire it up....
     
  6. buggman

    buggman Do not touch the trim!

    [​IMG]

    That diagram doesn't show pin 87a in the center, but 87 & 87a will have the opposite output.
    If 87 has 12v out 87a will have 0v & if 87a has 12v out 87 will have 0v out.
     
  7. OP
    klinger86

    klinger86 Moderator

    so basically 86 will be the flasher 85 will be the ground 30 will be the constant and 87 will go to the corner.... correct?
     
  8. buggman

    buggman Do not touch the trim!

    I think so. lol
    Either 87 or 87a to the new bulb.
     
  9. OP
    klinger86

    klinger86 Moderator

    [​IMG]

    here's a better diagram....

    now just to play around with it and see if i can get it to work.....
     
  10. OP
    klinger86

    klinger86 Moderator

    ok here is another schematic it is for converting a 3 bulb tail to a 2 bulb steup it should work for what i am doing.... the only thing that sucks is it will end up using 4 relays.... and some diodes....

    [​IMG]
     

Share This Page