Side exhaust or keep the rear exits?

[Redneck_ranger]

Alrighty, so my tailpipes are completely crooked, thanks to the outlet on my muffler rotting off... So, what does everybody think? Should I keep my exhaust coming out the rear, below the bumper, or should I get it to come out on the side, just before my rear tire?

 

[Hooligan]

Put up a pic of what it looks like now dude, I'd like that

 

[Redneck_ranger]

This is the only one I have as of right now. This was before the left one popped off. Imagine the left one down another inch, and sticking out about an inch farther than the right one...

Clinton, are you selling 4 31" mud tires on craigslist?
http://scranton.craigslist.org/pts/2675605885.html

 

[Redneck_ranger]

Well, that was a fail... Right one is the one that popped off... Hahahahahahaha

 

[Hooligan]

I can see well enough. I like it the way you have it

 

[Redneck_ranger]

Tell me that after it got plugged with mud on Saturday xD

 

[Hooligan]

Simple solution....STAY OUT OF THE MUD!!! LOL

 

[Redneck_ranger]

Yeah.... Uhhhhh, NOT HAPPENING!!! Lmao

 

[Demon]

Simple solution....STAY OUT OF THE MUD!!! LOL

or get mud tires. or get a running start. or dont stall the engine. or keep flooring it. would all be a simple thing as well

 

[Redneck_ranger]

Dude, flooring it don't get you nowhere. You'd be better off putting her in 4 low and crawling through it. And I intentionally stalled it now?

 

[Demon]

lmao its ok

 

[Captured Time]

i love my side exit im just saying

 

[Brodie_Laj]

I like the set up you got there, just move them tighter to the bumper

 

[Captured Time]

hey brodie what size you got on that rig?

 

[Redneck_ranger]

Brodie, I can't bend them without snapping the pipes... They're so old it's ridiculous lol The body lift is causing that... When I get new tailpipes, that's the first thing I'm going to do.

 

[Brodie_Laj]

Brodie, I can't bend them without snapping the pipes... They're so old it's ridiculous lol The body lift is causing that... When I get new tailpipes, that's the first thing I'm going to do.

oh my bad, i though you were going to be replacing them

 

[Brodie_Laj]

hey brodie what size you got on that rig?

It is 2 1/2 pipe welded in behind the cat and straight piped to a 3" magnaflow tip.. GoPro video for you
http://www.youtube.com/watch?v=5HShrRiGGqE

 

[Redneck_ranger]

That thing sounds amazing! Hahahaha

 

[Brodie_Laj]

thank you, it is not a bad setup if you wanted to do it like that, i think it cost me around $250 for all the 2 1/2" pipe and the 3" tip, and that is with labor included, took it to a shop to get it done because i dont have a welder or a pipe bender, they did a good job making it 1 solid pipe

 

[Redneck_ranger]

I'd probably just rig it up, or have my buddy weld the pipes together lol