She got a new look!

[twowheelin6]

Our trucks will never stop changing lol

 

[Redneck_ranger]

Unfortunately.... Hahaha

 

[cookiemonster]

Our trucks will never stop changing lol

If they ain't changing for the better...then there getting worse!

 

[Fx4wannabe01]

I just installed some 98 tow hooks on it. They serve more of a purpose than the grille guard.

Soon enough I'm gonna save up for a steel bumper with D rings on it. But for now, I'm doing what Fx4wannabe01 had at one point. A set of lights going across the front bumper, hopefully in the summer.

What'd you use to cut your valence?? A hacksaw???!??? Dremel tool???!??



Here's some after-the-fact tips. lol...

See notch at the top of the valence hole for the hitch...

:thumbdown: lol I need some ideas for my light setup. I want the four across the front, but I'm not sure what I should do to mount them? I'm kinda hoping Shane will get in here with all his knowledge hahaha

NEVER!!!!









But since you've been partially sane as of late, here's a teaser...

This teaser could be called full frontal. lol.

 

[Redneck_ranger]

Yes, I used a saw. Lmao. I'm gonna go back over it with a file today and shave it down and smooth it out. I didn't think a razor would cut through plastic this thick. And you're a persistent one, aintcha? Hahaha. I think I figured it out.

 

[Fx4wannabe01]

Yes, I used a saw. Lmao. I'm gonna go back over it with a file today and shave it down and smooth it out. I didn't think a razor would cut through plastic this thick. And you're a persistent one, aintcha? Hahaha. I think I figured it out.

It's just about putting a little bit of thought to what you're doing before making it look hack.... literally.

 

[hazard-maine]

the light bar set up is easy, id invest in getting one of those racheting wrenches for when you put the tabs on the bumper

 

[Redneck_ranger]

It's just about putting a little bit of thought to what you're doing before making it look hack.... literally.

Yeah, I always halfass my things then go back to clean em up later. It was 11:00 at night when I was doing em. Haha

the light bar set up is easy, id invest in getting one of those racheting wrenches for when you put the tabs on the bumper

I have a whole set of em already lol

 

[hazard-maine]

good your half way there

 

[Redneck_ranger]

I did end up trimming the valence a little, so it does look better than it originally did. I just need to file it down and be on my way to repainting the front bumper.