Discuss: Video How To: OHC Install

Well guys, heres where Im at:

Console.jpg


Its in! The damn things in! I just went ahead and did the power wire and nothing else. I WILL NOT remove my headliner again unless something is completely fudged up! Im awaiting a temp sensor from Pete then it oughta read something other than OC lol. I am SOO happy its basically over with! Thanks guys!
 
ill use this when/if i install mine. i just have get over cutting the headliner and completely figure out the wiring. you dont have to cut any of your factory wiring right?
 
mcdonald58 said:
ill use this when/if i install mine. i just have get over cutting the headliner and completely figure out the wiring. you dont have to cut any of your factory wiring right?
Click to expand...


Wiring is real easy. And for the headliner cut, just start small. You can actually keep the cut about an inch narrower than the bracket and be ok. Just use the bracket for the width measurement.

Follow the video and line up that tab with the roof.

You can do it! :thumbup:
 
Well, once you bolt the bracket in a drill and good bit work great. Thats in the video also. I used a 1/4" cobalt bit.

My first one I installed I used a dremel, that was bad because of the sparks, it burned up the headliner
 
You must log in or register to reply here.
Back
Top