Leaf spring hanger replacement

Discussion in 'Suspension Tech' started by doyouquaxu, Apr 14, 2013.

  1. doyouquaxu

    doyouquaxu FUUUUUUUUUUUUU

    I have an 01 sitting with no rear suspension on it currently. It has the modular frame, so the rear portion of the frame is separate from the front and cab portion of the frame. They're joined with 8 rivets per side, 4 of which are the rivets holding the leaf spring hangers on. The problem is that I can not get the rivets out of the frame to put the new hangers on.

    PB Blaster, big hammers, punches, grinding the rivets flat to the frame, and lots of curse words have not helped. The next thing I do is get the torch out unless someone has a better idea? I really don't wanna drop the tank to torch the drivers side ones.

    This is what I'm dealing with, the 4 holes on the side of the frame is where the rivets are stuck on mine. Pic pulled off the web for reference:
    [​IMG]
     
  2. Ranger Forum Sign Up!

    Join RangerForum.com Today - It's Totally Free!

    Are you a Ford Ranger fan? If so we invite you to join our community and see what it has to offer. Our site is specifically designed for you and it's a great place for Ford Ranger Fans to meet online.
    Once you join you'll be able to post messages, upload pictures of your Ford, and have a great time with other Ranger fans. Whether your an old timer or just bought your Ford you'll find that Ranger Forum is a great community to join. Best of all it's totally free!

    Join RnagerForum.com Today! JOIN FOR FREE

  3. mcdonald58

    mcdonald58 New Member

    When I did this job the bolts on one side came out with grinding the heads flat than a couple of whacks with a hammer. My teacher had to take a torch to get the rivets out of the frame.
     
  4. OP
    doyouquaxu

    doyouquaxu FUUUUUUUUUUUUU

    This is all rivets, none will budge. Heat and an air hammer were suggested by one person, but I don't have access to air tools where the truck is. Heat and a BFH might have to do, or drilling them out.
     
  5. Diablo

    Diablo New Member

    if you drill , use a cobalt bit.
     
  6. Brinker88

    Brinker88 Black sheep o' the family

  7. OP
    doyouquaxu

    doyouquaxu FUUUUUUUUUUUUU

    I have new hangers specifically for the spring pack that is going on the truck. The frame will be welded at the junction though
     
  8. cvar

    cvar New Member

    I used an ordinary HSS 3/8" drill bit to remove the rivets. After grinding off the rivet heads, make a dimple with a center punch, so the drill bit won't wander.
    Then drill into the rivets about 1/2" deep. Lastly, use a hammer & punch to knock out the remainder of the rivets.
    This works on even the toughest rivets. No heat needed.
     

Share This Page