Simple fire wall question

[Freemans 00]

I got these offroad lights sitting ready to be installed on my bull bar. All the wires are 1 single peice (all put together) anyways I was wondering how to get the switch part into the cab since my firewall is small? And where should I run my wires to to be hidden? Sorry no picture no camera at the moment

 

[Freemans 00]

never mind I found a solution. They come apart so itll fit.

 

[Hooligan]

For anyone else wondering there is a plug on the firewall behind the brake pedal

 

[Freemans 00]

Never noticed that part. Im assuming it will come off if needed?

 

[Hooligan]

yup it pops out but your better just poking a hole through it

 

[Black mamba]

Or you could poke a hole and feed the wire through the grommet so it doesn't short

 

[SalRanger2]

if you cant get that one to work i cut a slit in the hood latch cable grommet and that works good.

 

[Redneck_ranger]

yup it pops out but your better just poking a hole through it

This is how my off road lights are wired, and how I fed the wire through to my temp sensor for my OHC. Punched a hole right through. A word of advice though, go from the inside out.... It's a tight squeeze for a hand to fit to feed it from the outside in.

 

[Freemans 00]

This is how my off road lights are wired, and how I fed the wire through to my temp sensor for my OHC. Punched a hole right through. A word of advice though, go from the inside out.... It's a tight squeeze for a hand to fit to feed it from the outside in.

Thats weird because its the exact opposite for me. Hard to get to from the inside and under the hood its like a hole i can stick my foot in

 

[Redneck_ranger]

lol Could be different because yours is older

 

[Freemans 00]

hey you dissing on my truck cause its old?

 

[Redneck_ranger]

Nah lol I want one that's older

 

[Freemans 00]

there you go again saying that word older.... lol

 

[Redneck_ranger]

I want a 94 haha

 

[Freemans 00]

I want a 69... I mean 89

 

[Redneck_ranger]

lol...