Replacing front rotors

H

hanninryu

New Member
Hi I own a 2008 ranger XL 2.3L engine 2WD and i'm trying to replace my old rotor. I have all of the parts as far as i know. The problem i am having is getting the bearings and all to line up properly. Any ideas and or help would be greatly appreciated.
 
Check and see if you have the rear bearing in backwards. The cone should sit flush in the race. You'll have to carefully remove the grease seal in the back.

If that checks out, the rotor should slide on and you'll be able to slide the outer bearing on. Good luck
 
You must log in or register to reply here.
Back
Top