Dtc p1336

[floridajake69]

I have always been able to fix a problem after knowing the trouble code, until now. I have replaced both the cam sensor and the crank sensor. I still get the trouble code and experience the same problems. I was hoping some one would have some suggestions on what to do next. Am I doing something wrong or missing something?
Thanks.

 

[Redneck_ranger]

What are the symptoms of your problem?

 

[Hurley]

Yeah dude we kinda gotta know what your problem is first

 

[Redneck_ranger]

Or at least the definition of the code...

 

[floridajake69]

DTC P1336
Crankshaft Position or Camshaft Position Input Signal To Powertrain Control Module Concerns.

It feels as if the timing is off. Major hesitation when you floor it. Runs OK on the Interstate at 75 mph. Gets horrible mileage overall. Less than 10 MPG.

 

[Redneck_ranger]

Spark plugs and wires changed? New coil pack installed? Could be a bad injector or something along the lines of that as well.

 

[floridajake69]

New plugs, wires, and coil pack.

 

[Redneck_ranger]

Then it could be an issue with the electrical wiring before the sensors and such. Did you check for cust, stretches, breaks, etc...?

 

[Hooligan]

This is something I am not too familiar with. I can recommend any wiring harness or plugs that may cause the code should be given a shot of electrode cleaner. Could be as simple as dirty, gummed up pins or something