burnt valve replacement

J

joncf

New Member
I just removed the right head and it has a hole the #1 exhuast valve. Just wondering I should replace all of them or ok if I just do the one. And also should I do the other head or is that wasting cash?
 
if only one valve is bad that is all you need to replace, just the bad ones no need to replace the good valves with new ones. but I would also chk both sides
 
ok ... also when I did compression test the cylinder #2 had around 130psi and all others had 150+ thats why I was thinking of maybe change valve on that one maybe its starting to loss seat or wearing. I will take the other head off tomorrow while I have it apart and check it though. thanks
 
freshen up the valves ( re-seat) and if you have the excess cash do a ring job on all cylinders and bottle brush the cylinders.
 
You must log in or register to reply here.
Back
Top