94 Ranger W/clutch hydraulic problem

Discussion in '1993 - 1997 Ford Ranger' started by patrick.timms, Sep 28, 2010.

  1. patrick.timms

    patrick.timms 94 ranger xlt

    I have changed my clutch before and have had no problem bleeding my clutch.Recently I have changed the flywheel,clutch,pressure plate,slave cylinder with throw out bearing pre-filled and after having problems bleeding,a new clutch master cylinder.I have bleed the system before and it has never been this much of a pain.I have bleed the system numerous times and numerous ways including bench bleeding the system out of the truck all was good with great tension once I put it in the truck no help and I lost pressure.with the engine running,there is no shifting into gear(any gear)I'm wondering if there is something I have forgot it has been a while since the last time I did this but it seemed easier and quicker then.Any Suggestions are greatly appreciated.
    Last edited: Sep 28, 2010
  2. Ranger Forum Sign Up!

    Join RangerForum.com Today - It's Totally Free!

    Are you a Ford Ranger fan? If so we invite you to join our community and see what it has to offer. Our site is specifically designed for you and it's a great place for Ford Ranger Fans to meet online.
    Once you join you'll be able to post messages, upload pictures of your Ford, and have a great time with other Ranger fans. Whether your an old timer or just bought your Ford you'll find that Ranger Forum is a great community to join. Best of all it's totally free!

    Join RnagerForum.com Today! JOIN FOR FREE

  3. ford

    ford New Member

    Ive had kindof the same problem. My clutch just recently went out so i replaced it, bled it, then i drove it for one day. I had lost all of my fluid, it was my clutch master cylinder that was leaking. After i replaced that i rebled the system and it wouldnt work i tryed it the other method and the clutch pedel got so hard to move. Also when id push the clutch in in neut
    ral the motor would bog down.
  4. ghost

    ghost New Member

    Try this?

    im runnin a 93 ranger and i was havin that problem last december after i threw a new clutch kit in mine i figured out that the line the goes into the slave popped out about half and inch i just tapped it in with a screwdriver and it hasnt leaked since maybe u should try it.

Share This Page