It isn't an allen. It is 3/8" square. Just stick a 3/8" ratchet in there and use it. You may have to clean out any rust or debris but, that's all...
Is anyone else having issues reaching the forum? Or, is it just me? For most of the past week I kept getting "server error. Try again later" every...
The setup of your ring and pinion (pinion depth, ring gear backlash etc) is designed to keep everything quiet in all conditions. With the noise...
I would remove the top cover and inspect the shift forks, if it's a used trans. The 5 speed manual trans in the Ranger (and some F-150's) has the...
Looks good!
Good luck. Intermittent problems suck!
Let us know how you make out.
It's been a long time and forgive me if I'm incorrect but, I think that truck has an electronic speedometer. If the speedo works and the cruise...
198,000
It sounds like the front pump seal is leaking. Often times they will blow this seal out and cause a significant leak. You'll notice "stake" marks...
Its probably related to what you just did. It sounds like a vacuum issue. When there is a vacuum problem the HVAC controls default to defrost. I...
I believe they will physically bolt up. And, they are very similar to each other internally. However, it would probably operate as a 4 speed...
Bob, The 2000 (I think) and earlier 4.0l engines have the exact same type of timing chain setup as the 3.0l. I have a 94 with 190000 miles on it...
Could you hear the fuel pump before it broke down? I have a 94 4.0l and I cant hear my fuel pump, ever. Even with the bed off. Make sure you have...
It should have abs sensors in the front regardless if its 2wd. The trans range sensor is on the side of the trans, at the shift linkage. Used to...
Just a thought. Have you tried replacing the Trans Range sensor? I remember back from my dealership days that you could get some pretty strange...
Hmmm. I'm not sure what's going there. If I think of anything I'll let you know. Pete
Ok. I'm a little rusty here. When you scan the truck, is there more than one option for modules to check? For example, is there a body control...
O/D light flashing means that the PCM detected a transmission fault at some point. The harsh shifting is the trans in "failsafe" mode to protect...
Thanks!
Separate names with a comma.