Recent content by Ret_Marine2003

There is a very similar post at the top of the page. This is a fairly easy DIY project. I used a piece of aluminum that I ground to fit perfectly and drilled a hole in each corner. I did nothing more, but the one I did prior was more like the member who started the thread's solution. I used...

If the bottom bothers you, tape off the area you do not want adhesive on, grab a clean poly-foam place mat that is resonsbly close from Dollar Tree, Walmart, etc. cut it to size, and use 3M spray adhesive on the area you want covered. The good adhesive spray should do the job, but if it...

New Owner of a simple 2WD, standard transmission, regular cab 1998 Ford Ranger with 80,000 original miles.