Recent content by kanuck15

Searching for something else on here I forgot about this thread. Traded the ranger off last september for this did a decent amount of work and here it is now and the engine that is about to be dropped into it

Dont know if this will help http://www.therangerstation.com/tech_library/diagrams/91-94_Ranger_vacuum_hose_diagram.gif

Wiring issue at the fuel pump. Loose connection somewhere

Just here to help! I will try to drum up a picture and see if I can point out where the valve/regulator are

Sounds like it needs the fluid changed and maybe the valve body cleaned On that note talk to who rebuilt it. They might have some insight and even better a warranty with it?

No problem. I forgot to mention 35-45 psi is what you are looking for

There should be a schrader valve (looks like a tire valve stem) on the fuel rail somewhere. Thats where you check pressure at

Welcome! To me that price seems high. But I dont know much about newer rangers. My knowledge base ends around 2003

Im guessing by fire you mean spark? Ok does it have fuel? Being an 86 im thinking its carb. So can you watch fuel go through the carb?

Welcome! I posted in your other thread as well. Ive messed with these 3.0s a little bit so I will try to help

you didnt plug something back in correctly. Check around the coil plug and whatnot.

Glad its fixed! Id still look for a vacuum leak. A back fire isnt normal and will only get worse

28 seems rather low. It should be 40 or so? As far as the miss I would look for a vacuum leak. A backfire is a dead give away of a vacuum leak. Could also be the fuel pressure issue

No problem. There is a fellow on here who is a wiz with seats. He is selling some mustang buckets in the classified section. Shoot him a message and ask his opinion. He would probably know what factory parts to get to do what you want

I think you are into custom work here. If the truck were a super cab (guessing its not being 4 cylinder and 2wd) you could put explorer power seats in that can raise up. You can put them in a reg cab but it takes some fab work on the brackets