Recent Content by bowmaster85

  1. bowmaster85
    Post

    Keyless Ignition System

    I have the same idea with mine but there are a few problems. Locks only stop the honest theves and any two bit mechanic now how to get around...
    Post by: bowmaster85, Oct 9, 2009 in forum: 1998 - 2011 Ford Ranger
  2. bowmaster85
    Post

    Gauge panel

    problem is that the 97 to the 99 is a diffrent generation and its hard to say that its the same wiring. Ford started adding more goodies in 98...
    Post by: bowmaster85, Oct 9, 2009 in forum: 1998 - 2011 Ford Ranger
  3. bowmaster85
    Post

    Rear Diff Oil and Addititve?

    if you jack up the rear end of the truck and turn the one wheel the other shoul turn the same distance. It would also help if you had someone...
    Post by: bowmaster85, Oct 9, 2009 in forum: Maintenance Shop
  4. bowmaster85
    Post

    panted bezel need help

    what type of paint did you use? I found that the Fusion paint and plastics paint work good. Even though it feels strong, it flexes and breaks...
    Post by: bowmaster85, Oct 9, 2009 in forum: 1998 - 2011 Ford Ranger
  5. bowmaster85
    Post

    1998 will not start

    When ever I suspect fuel problems I always recommend to check the fuel filter. Its cheap and easy to replace. Then when you pull the old one,...
    Post by: bowmaster85, Oct 9, 2009 in forum: General Discussion
  6. bowmaster85
    Post

    93 tranny noise

    What did the fluid look like? How much metal was on the fill plug? Most fill and drain plugs are magnetic to pick up any shavings in the oil. If...
    Post by: bowmaster85, Oct 8, 2009 in forum: 1993 - 1997 Ford Ranger
  7. bowmaster85
    Post

    need help with ac troubleshooting

    When you say that it stops blowing what do you mean?? does it stop blowing out the vents and start going through the dash vents? or does is sound...
    Post by: bowmaster85, Oct 8, 2009 in forum: Maintenance Shop
  8. bowmaster85
    Post

    Engine stalls

    fuel Couple of questions...Did you check the fuel pressure and how much do you have at the fuel rail. the port should be at end of the rail. It...
    Post by: bowmaster85, Oct 8, 2009 in forum: 1993 - 1997 Ford Ranger
  9. bowmaster85
    Thread

    DOHC Focus Ztech Head

    Any one know if the DOHC Focus Ztec head will match up to the 2.3L block. If the water jackets hang over thats fine but will the bore, water...
    Thread by: bowmaster85, Oct 4, 2009, 0 replies, in forum: 1993 - 1997 Ford Ranger
  10. bowmaster85
    Post

    Shutters after new clutch

    Adjustable pressure plate On some of the years there is also an adjustable pressure plate. If the mechanic did not notice this or adjust the...
    Post by: bowmaster85, Oct 4, 2009 in forum: 1993 - 1997 Ford Ranger
  11. bowmaster85
    Post

    Largest Thing you've towed

    Pallet Cant say it was a pallet of pavers. But it was enough pavers that the front end lifted off the ground going accross intersections for 20...
    Post by: bowmaster85, Oct 4, 2009 in forum: Drivetrain Tech
  12. bowmaster85
    Post

    rough idle, misses at low RPM

    Codes?? Have you tried to drain the fuel and put fresh gas in it??? What are the codes for the check engine light......The computer threw the...
    Post by: bowmaster85, Oct 4, 2009 in forum: 3.0 Engine
  13. bowmaster85
    Post

    Hood Deflectors

    They are ok I have one on my 97. I noticed that it does change the aerodynamics of the hood area. From what I can tell with "love bug season"...
    Post by: bowmaster85, Oct 4, 2009 in forum: General Discussion
  14. bowmaster85
    Post

    Debadging Truck

    From what I understand with my 1997 is that there is a hole behind the fender badges. I dont know how big the hole is but it should be there.
    Post by: bowmaster85, Oct 4, 2009 in forum: 1998 - 2011 Ford Ranger